طراحی یکپارچه تخمین‌گر عیب و کنترل‌کننده تحمل‌پذیر عیب برای سیستم‌های خطی پارامتر متغیر با عیب عملگری و حسگری
محورهای موضوعی : مهندسی برق و کامپیوترهوشنگ جعفری 1 , امین رمضانی 2 , مهدی فروزان فر 3
1 - دانشگاه تربیت مدرس
2 - دانشگاه تربیت مدرس
3 - دانشگاه آزاد اسلامی واحد اهواز
کلید واژه: تخمین‌گر عیب, سیستم خطی پارامتر متغیر, کنترل‌کننده تحمل‌پذیر عیب, نامساوی ماتریس خطی,
چکیده مقاله :
وقوع عیب در سیستم‌های واقعی عملاً غیر قابل اجتناب بوده و می‌تواند باعث کاهش عملکرد و حتی واردشدن خسارت غیر قابل جبران مالی و جانی گردد. از این رو مداخله به‌موقع و سریع با اتخاذ تصمیم‌های مناسب به جهت جلوگیری از صدمات ناشی از عیب بسیار حیاتی است. همین امر استفاده از روش‌های کنترل تحمل‌پذیر عیب را برای جبران اثرات مخرب عیب در سیستم و افزایش قابلیتاطمینان و امنیت آن بسیار ضروری می‌نماید. در این مقاله روشی برای تخمین و کنترل وقوع عیب عملگری و حسگری به‌صورت هم‌زمان با استفاده از طراحییک تخمین‌گر عیب و کنترل‌کننده تحمل‌پذیر عیب به‌صورت یکپارچه برای سیستم‌های خطی متغیر با زمان ارائه گردیده است. در این روش از یک تخمین‌گر مبتنی بر رؤیتگر ورودی ناشناخته با کنترل‌کننده حالت و مد لغزشی به جهت اطمینان از پایداری مقاوم سیستم از طریق حل نامساوی ماتریس خطی استفاده شده است. روش ارائه‌شده، روییک سیستم خطی با پارامتر متغیر اعمال گردیده و نتایج شبیه‌سازی، مؤثربودن این روش برای تخمین عیوب و پایداری سیستم را نشان می‌دهد.
Fault occurrence in real operating systems usually is inevitable and it may lead to performance degradation or failure and requires to be meddled quickly by making appropriate decisions, otherwise, it could cause major catastrophe. This gives rise to strong demands for enhanced fault tolerant control to compensate the destructive effects and increase system reliability and safety in the presence of faults. In this paper, an approach for estimation and control of simultaneous actuator and sensor faults is presented by using integrated design of a fault estimation and fault tolerant control for time-varying linear systems. In this method, an unknown input observer-based fault estimation approach with both state feedback control and sliding mode control was developed to assure the closed-loop system's robust stability via solving a linear matrix inequality formulation. The presented method has been applied to a linear parameter varying system and the simulation results show the effectiveness of this method for fault estimation and system stability.
[1] P. A. Moradmand and H. Khaloozadeh, "An experimental study of modeling and self-tuning regulator design for an electro-hydro servo-system," in Proc. 5th IEEE Int. Conf. on Control, Instrumentation, and Automation, ICCIA'17, pp. 126-131, Shiraz, Iran, 21-23 Nov. 2017.
[2] M. Dorostian and A. Moradmand, "Hierarchical robust model-based predictive control in supply chain management under demand uncertainty and time-delay," in Proc. 7th IEEE Int. Conf. on on Control, Instrumentation and Automation, ICCIA'21, 6 pp., Tabriz, Iran, 23-24 Feb. 2021.
[3] A. Moradmand, M. Dorostian, and B. Shafai, "Energy scheduling for residential distributed energy resources with uncertainties using model-based predictive control," International J. of Electrical Power & Energy Systems vol. 132, Article ID: 107074, Nov. 2021.
[4] A. Oloomi and H. Khanmirza, "Fault tolerance of RTMP protocol for live video streaming applications in hybrid software-defined networks," J. of Electrical and Computer Engineering Innovations, vol. 7, no. 2, pp. 241-250, Jul. 2019.
[5] S. Khodakaramzadeh, M. Ayati, and M. R. Hairi-Yazdi, "Fault diagnosis of a permanent magnet synchronous generator wind turbine," J. Electr. Comput. Eng. Innovations, vol. 9, no. 2, pp. 143-152, Jul. 2021.
[6] M. A. Massoumnia, "A geometric approach to the synthesis of failure detection filters," IEEE Trans. on Automatic Control, vol. 31, no. 9, pp. 839-846, Sept. 1986.
[7] H. Hammouri, M. Kinnaert, and E. H. El Yaagoubi, "Observer-based approach to fault detection and isolation for nonlinear systems," IEEE Trans. on Automatic Control, vol. 44, no. 10, pp. 1879-1884, Oct. 1999.
[8] M. Blanke, M. Kinnaert, J. Lunze, M. Staroswiecki, and J. Schröder, Diagnosis and Fault-Tolerant Control, vol. 2, Berlin: Springer, 2006.
[9] R. J. Patton and J. Chen, "Observer-based fault detection and isolation: robustness and applications," Control Engineering Practice, vol. 5, no. 5, pp. 671-682, May 1997.
[10] J. Chen and Ron J. Patton, Robust Model-Based Fault Diagnosis for Dynamic Systems, Kluwer AcademicPublishers, USA, 1999.
[11] C. Nie and R. J. Patton, "Fault estimation and MRC-based active FTC," IFAC Proceedings Volumes, vol. 44, no. 1, pp. 14808-14813, Jan. 2011.
[12] P. Shi, M. Liu, and L. Zhang, "Fault-tolerant sliding-mode-observer synthesis of Markovian jump systems using quantized measurements," IEEE Trans. on Industrial Electronics, vol. 62, no. 9, pp. 5910-5918, Sept. 2015.
[13] L. Yao and L. Feng, "Fault diagnosis and fault tolerant tracking control for the non-Gaussian singular time-delayed stochastic distribution system with PDF approximation error," Neurocomputing, pt. A, vol. 175, pp. 538-543, Jan. 2016.
[14] X. Li and F. Zhu, "Fault‐tolerant control for Markovian jump systems with general uncertain transition rates against simultaneous actuator and sensor faults," International J. of Robust and Nonlinear Control, vol. 27, no. 18, pp. 4245-4274, Dec. 2017.
[15] M. Zhong, S. X. Ding, J. Lam, and H. Wang, "An LMI approach to design robust fault detection filter for uncertain LTI systems," Automatica, vol. 39, no. 3, pp. 543-550, Mar. 2003.
[16] J. Lan and R. J. Patton, "A new strategy for integration of fault estimation within fault-tolerant control," Automatica, vol. 69, pp. 48-59, Jul. 2016.
[17] J. Lan and R. J. Patton, "Integrated fault estimation and fault‐tolerant control for uncertain Lipschitz nonlinear systems," International J. of Robust and Nonlinear Control, vol. 27, no. 5, pp. 761-780, Mar. 2017.
[18] J. Lan and R. J. Patton, "Integrated design of fault-tolerant control for nonlinear systems based on fault estimation and T-S fuzzy modeling," IEEE Trans. on Fuzzy Systems, vol. 25, no. 5, pp. 1141-1154, Oct. 2016.
[19] X. Li, D. Lu, G. Zeng, J. Liu, and W. Zhang, "Integrated fault estimation and non-fragile fault-tolerant control design for uncertain Takagi-Sugeno fuzzy systems with actuator fault and sensor fault," IET Control Theory & Applications, vol. 11, no. 10, pp. 1542-1553, Jul. 2017.
[20] Y. Liu and G. H. Yang, "Integrated design of fault estimation and fault-tolerant control for linear multi-agent systems using relative outputs," Neurocomputing, vol. 329, pp. 468-475, Feb. 2019.
[21] C. Hoffmann and H. Werner, "A survey of linear parameter-varying control applications validated by experiments or high-fidelity simulations," IEEE Trans. on Control Systems Technology, vol. 23, no. 2, pp. 416-433, Mar. 2014.
[22] A. Casavola, D. Famularo, and G. Franze, "A feedback min-max MPC algorithm for LPV systems subject to bounded rates of change of parameters," IEEE Trans. on Automatic Control, vol. 47, no. 7, pp. 1147-1153, Jul. 2002.
[23] G. Gagliardi, A. Casavola, and D. Famularo, "A fault detection and isolation filter design method for Markov jump linear parameter‐varying systems," International J. of Adaptive Control and Signal Processing, vol. 26, no. 3, pp. 241-257, Mar. 2012.
[24] A. Casavola, D. Famularo, and G. Gagliardi, "A linear parameter varying fault detection and isolation method for internal combustion spark ignition engines," International J. of Robust and Nonlinear Control, vol. 24, no. 14, pp. 2018-2034, Sept. 2014.
[25] M. Rodrigues, D. Theilliol, S. Aberkane, and D. Sauter, "Fault tolerant control design for polytopic LPV system," International J. of Applied Mathematics and Computer Science, vol. 17, no. 1, pp. 27-37, 2007.
[26] R. J. Patton, L. Chen, and S. Klinkhieo, "An LPV pole-placement approach to friction compensation as an FTC problem," International J. of Applied Mathematics and Computer Science, vol. 22, no. 1, pp. 149-160, Mar. 2012.
[27] F. Shi and R. J. Patton, "Fault estimation and active fault tolerant control for linear parameter varying descriptor systems," International J. of Robust and Nonlinear Control, vol. 25, no. 5, pp. 689-706, Mar. 2015.
[28] M. M. Seron and J. A. De Doná, "Robust fault estimation and compensation for LPV systems under actuator and sensor faults," Automatica, vol. 52, pp. 294-301, Feb. 2015.
[29] K. P. B. Chandra, H. Alwi, and C. Edwards, "Fault detection in uncertain LPV systems with imperfect scheduling parameter using sliding mode observers," European J. of Control, vol. 34, pp. 1-15, Mar. 2017.
[30] H. Rezaei and M. J. Khosrowjerdi, "A polytopic LPV approach to active fault tolerant control system design for three-phase induction motors," International J. of Control, vol. 90, no. 10, pp. 2297-2315, Jun. 2017.
[31] S. Varrier, D. Koenig, and J. J. Martinez, "Integrated fault estimation and fault tolerant control design for lpv systems," IFAC Proceedings Volumes, vol. 46, no. 2, pp. 689-694, 2013.
[32] R. Tayari, A. Ben Brahim, F. Ben Hmida, and A. Sallami, "Active fault tolerant control design for LPV systems with simultaneous actuator and sensor faults," Mathematical Problems in Engineering, vol. 2019, Article ID 5820394, 14 pp., 2019.
[33] P. Apkarian, P. Gahinet, and G. Becker, "Self-scheduled H∞ control of linear parameter-varying systems: a design example," Automatica, vol. 31, no. 9, pp. 1251-1261, Sept. 1995.
[34] B. D. Anderson and S. Vongpanitlerd, Network Analysis and Synthesis: A Modern Systems Theory Approach, Dover Publications, New York, USA, 2006.
[35] M. Corless and J. A. Y. Tu, "State and input estimation for a class of uncertain systems," Automatica, vol. 34, no. 6, pp. 757-764, Jun. 1998.
[36] S. Mammar and D. Koenig, "Vehicle handling improvement by active steering," Vehicle System Dynamics, vol. 38, no. 3, pp. 211-242, 2002.
