Linearity Enhanced Noise Cancelling Low Noise Amplifier for Ultra-Wideband Application
محورهای موضوعی : Radio frequency and Microwave Engineering
Nileshkumar K Patel
1
,
HASMUKH P KORINGA
2
1 - Gujarat Technological University
2 - Government Engineering College Rajkot Gujarat India
کلید واژه: Noise Cancellation, LNA-Low Noise Amplifier, CM-Current Mirror, CG-Common Gate, Linearity, Complementary, UWB-Ultrawideband,
چکیده مقاله :
The Low Noise Amplifier (LNA) stands as a crucial element RF receiver chain, demanding a delicate interplay of characteristics such as high gain, low noise figure (NF), superior linearity, and an extensive dynamic range. De-signing an ultrawideband (UWB) LNA poses a complex challenge as engineers grapple with intricate trade-offs inherent in these parameters. To address these challenges, noise cancellation techniques have emerged as valuable tools, revolutionizing the design of UWB LNAs by relaxing the traditional trade-off between bandwidth and input matching. This innovative approach not only enhances bandwidth but also effectively cancels out the un-desirable noise and nonlinearities from the input MOSFET. Despite the advancements afforded by noise cancellation, the broad bandwidth of UWB LNAs presents a significant hurdle. If the linearity is insufficient, the UWB LNA faces performance degradation due to increase in-band interference. In response, this article proposes an inventive linearization technique, a combination of Noise Cancelling (NC) and complementary derivative super-position (CDS), aiming to increase the linearity of UWB LNAs. Through meticulous simulations conducted using Cadence Virtuoso with GPDK090 library, the proposed LNA showcases impressive performance metrics across the UWB spectrum. Notably, it achieves a gain ranging from 12.5 dB to 15.5 dB, a noise figure within the range of 3.9 dB to 5.26 dB, and an IIP3 spanning from 6.3 dBm to 8.8 dBm. Remarkably, this innovative LNA accomplishes these feats while operating with a modest power consumption of 11.36 mW from a 1.2 V supply. This groundbreaking technique holds promise for significantly enhancing the efficiency and overall performance of UWB LNAs within contemporary RF receiver systems.
The Low Noise Amplifier (LNA) stands as a crucial element RF receiver chain, demanding a delicate interplay of characteristics such as high gain, low noise figure (NF), superior linearity, and an extensive dynamic range. De-signing an ultrawideband (UWB) LNA poses a complex challenge as engineers grapple with intricate trade-offs inherent in these parameters. To address these challenges, noise cancellation techniques have emerged as valuable tools, revolutionizing the design of UWB LNAs by relaxing the traditional trade-off between bandwidth and input matching. This innovative approach not only enhances bandwidth but also effectively cancels out the un-desirable noise and nonlinearities from the input MOSFET. Despite the advancements afforded by noise cancellation, the broad bandwidth of UWB LNAs presents a significant hurdle. If the linearity is insufficient, the UWB LNA faces performance degradation due to increase in-band interference. In response, this article proposes an inventive linearization technique, a combination of Noise Cancelling (NC) and complementary derivative super-position (CDS), aiming to increase the linearity of UWB LNAs. Through meticulous simulations conducted using Cadence Virtuoso with GPDK090 library, the proposed LNA showcases impressive performance metrics across the UWB spectrum. Notably, it achieves a gain ranging from 12.5 dB to 15.5 dB, a noise figure within the range of 3.9 dB to 5.26 dB, and an IIP3 spanning from 6.3 dBm to 8.8 dBm. Remarkably, this innovative LNA accomplishes these feats while operating with a modest power consumption of 11.36 mW from a 1.2 V supply. This groundbreaking technique holds promise for significantly enhancing the efficiency and overall performance of UWB LNAs within contemporary RF receiver systems.
[1] Z. Liu, C. C. Boon, X. Yu, C. Li, K. Yang, and Y. Liang, “A 0.061-mm21-11-GHz noise-canceling low-noise amplifier employing active feedforward with simultaneous current and noise reduction,” IEEE Trans. Microw. Theory Tech., vol. 69, no. 6, pp. 3093–3106, 2021, doi: 10.1109/TMTT.2021.3061290.
[2] “2.2 UWB IET Circuits Devices Syst - 2020 - Hayati - Ultra‐wideband complementary metal‐oxide semiconductor low noise amplifier.pdf.”
[3] S. Arshad, R. Ramzan, K. Muhammad, and Q. U. Wahab, “A sub-10mw, noise cancelling, wideband LNA for UWB applications,” AEU - Int. J. Electron. Commun., vol. 69, no. 1, pp. 109–118, 2015, [Online]. Available: http://dx.doi.org/10.1016/j.aeue.2014.08.002.
[4] Q. Wan, Q. Wang, and Z. Zheng, “Design and analysis of a 3.1-10.6 GHz UWB low noise amplifier with forward body bias technique,” AEU - Int. J. Electron. Commun., vol. 69, no. 1, pp. 119–125, 2015, [Online]. Available: http://dx.doi.org/10.1016/j.aeue.2014.08.001.
[5] Z. Liu and C. C. Boon, “A 0.092-mm22-12-GHz Noise-Cancelling Low-Noise Amplifier With Gain Improvement and Noise Reduction,” IEEE Trans. Circuits Syst. II Express Briefs, vol. 69, no. 10, pp. 4013–4017, 2022, doi: 10.1109/TCSII.2022.3185455.
[6] H. Yu, Y. Chen, C. C. Boon, S. Member, P. Mak, and R. P. Martins, “LNA With Dual Complementary pMOS – nMOS Configuration,” vol. 68, no. 1, pp. 144–159, 2020.
[7] Z. Pan, C. Qin, Z. Ye, Y. Wang, and Z. Yu, “Wideband Inductorless Low-Power LNAs with Gm Enhancement and Noise-Cancellation,” IEEE Trans. Circuits Syst. I Regul. Pap., vol. 65, no. 1, pp. 26–38, 2018, doi: 10.1109/TCSI.2017.2710057.
[8] B. Razavi, RF Microelectronics (Prentice Hall Communications Engineering and Emerging Technologies Series), 2nd ed. USA: Prentice Hall Press, 2011.
[9] A. Bozorg and R. B. Staszewski, “A 0.02-4.5-GHz LN(T)A in 28-nm CMOS for 5G Exploiting Noise Reduction and Current Reuse,” IEEE J. Solid-State Circuits, vol. 56, no. 2, pp. 404–415, 2021, doi: 10.1109/JSSC.2020.3018680.
[10] P. B. T. Huynh, J. H. Kim, and T. Y. Yun, “Dual-Resistive Feedback Wideband LNA for Noise Cancellation and Robust Linearization,” IEEE Trans. Microw. Theory Tech., vol. 70, no. 4, pp. 2224–2235, 2022, doi: 10.1109/TMTT.2021.3139331.
[11] H. Yu, Y. Chen, C. C. Boon, C. Li, P. I. Mak, and R. P. Martins, “A 0.044-mm2 0.5-To-7-GHz Resistor-Plus-Source-Follower-Feedback Noise-Cancelling LNA Achieving a Flat NF of 3.3±0.45 dB,” IEEE Trans. Circuits Syst. II Express Briefs, vol. 66, no. 1, pp. 71–75, 2019, doi: 10.1109/TCSII.2018.2833553.
[12] J. Yan et al., “A 0.2-3 GHz Inductor-Less LNA Using Noise-Canceling and Dual-Resistor Feedback Technique,” IEEE Trans. Circuits Syst. II Express Briefs, vol. 72, no. 3, pp. 469–473, 2025, doi: 10.1109/TCSII.2025.3531994.
[13] T. Han, Z. Li, and M. Tian, “An inductor-less CMOS broadband balun gm-boosting LNA exploiting noise cancellation techniques,” Analog Integr. Circuits Signal Process., vol. 104, no. 2, pp. 121–129, 2020, doi: 10.1007/s10470-020-01665-2.
[14] D. Kim, S. Jang, J. Lee, and D. Im, “A Broadband PVT-Insensitive All-nMOS Noise-Canceling Balun-LNA for Subgigahertz Wireless Communication Applications,” IEEE Microw. Wirel. Components Lett., vol. 31, no. 2, pp. 165–168, 2021, doi: 10.1109/LMWC.2020.3042233.
[15] G. Feng et al., “Pole-Converging Intrastage Bandwidth Extension Technique for Wideband Amplifiers,” IEEE J. Solid-State Circuits, vol. 52, no. 3, pp. 769–780, 2017, doi: 10.1109/JSSC.2016.2641459.
[16] P. E. Allen and D. R. Holberg, CMOS Analog Circuit Design. Oxford University Press, 2016.
[17] S. Shahrabadi, “Ultrawideband LNA 1960–2019: Review,” IET Circuits, Devices Syst., vol. 15, no. 8, pp. 697–727, 2021, doi: 10.1049/cds2.12071.
[18] N. K. Patel and H. P. Koringa, “Systematic Analysis of Linearization Techniques for Wideband RF Low-Noise Amplifier,” in Advances in VLSI and Embedded Systems, 2023, pp. 27–44.
[19] R. Zhou, S. Liu, J. Liu, Y. Liang, and Z. Zhu, “A 0.1-3.5-GHz Inductorless Noise-Canceling CMOS LNA with IIP3 Optimization Technique,” IEEE Trans. Microw. Theory Tech., vol. 70, no. 6, pp. 3234–3243, 2022, doi: 10.1109/TMTT.2022.3161279.
[20] J. Chen, B. Guo, B. Zhang, and G. Wen, “A Highly Linear Wideband CMOS LNTA Employing Noise/Distortion Cancellation and Gain Compensation,” Circuits, Syst. Signal Process., vol. 36, no. 2, pp. 474–494, 2017, doi: 10.1007/s00034-016-0320-9.
[21] Z. Liu, C. C. Boon, C. Li, K. Yang, Y. Dong, and T. Guo, “A 0.0078mm2 3.4mW Wideband Positive-feedback-Based Noise-Cancelling LNA in 28nm CMOS Exploiting G_m Boosting,” Dig. Tech. Pap. - IEEE Int. Solid-State Circuits Conf., vol. 2022-Febru, pp. 142–144, 2022, doi: 10.1109/ISSCC42614.2022.9731719.
[22] B. Guo, J. Chen, Y. Wang, H. Jin, and G. Yang, “A wideband complementary noise cancelling CMOS LNA,” Dig. Pap. - IEEE Radio Freq. Integr. Circuits Symp., vol. 2016-July, pp. 142–145, 2016, doi: 10.1109/RFIC.2016.7508271.
[23] A. Bozorg and R. B. Staszewski, “A 20 MHz-2 GHz Inductorless Two-Fold Noise-Canceling Low-Noise Amplifier in 28-nm CMOS,” IEEE Trans. Circuits Syst. I Regul. Pap., vol. 69, no. 1, pp. 42–50, 2022, doi: 10.1109/TCSI.2021.3092960. [24] A. D. Martinez-Perez, F. Aznar, D. Flandre, and S. Celma, “Design-Window Methodology for Inductorless Noise-Cancelling CMOS LNAs,” IEEE Access, vol. 10, pp. 29482–29492, 2022, doi: 10.1109/ACCESS.2022.3158356.
[25] Z. Liu, C. Chye Boon, and Y. Dong, “A 0.6 V, 1.74 mW, 2.9 dB NF Inductorless Wideband LNA in 28-nm CMOS Exploiting Noise Cancellation and Current Reuse,” IEEE Trans. Circuits Syst. I Regul. Pap., vol. 71, no. 8, pp. 3561–3572, 2024, doi: 10.1109/TCSI.2024.3408901.
[26] M. A. Karami, M. Lee, R. Mirzavand, and K. Moez, “A 0.1-20.1-GHz Wideband Noise-Canceling gm-Boosted CMOS LNA with Gain-Reuse,” IEEE Trans. Microw. Theory Tech., vol. 72, no. 5, pp. 2990–3000, 2024, doi: 10.1109/TMTT.2023.3323042.
